Factory Pinion damper installed on all 2003 Cobra's.
This must be removed when installing the polyurethane differential bushings.
Both nut and bolt head require 18mm deep socket and box wrench to remove.

The new bushings will be installed where the arrows indicate.

Installation on the Mustang is very much the same as the Thunderbird installation.

Then tighten the nut to 30-40 ft lb MAX to set proper bushing preload.
Note: Overtighting the nut will cause the sleeve to cut into the washer.

Tools Needed:

• Jack and Jack Stands
• 15mm open end wrench (18mm cobra)
• 21mm deep socket (18mm cobra)
• 6" extension
• Torque wrench